Project Topic

DESIGN AND INSTALLATION OF 200 WATT SOLAR POWER SYSTEM

Project Attributes
 Format: MS word ::   Chapters: 1-5 ::   Pages: 44 ::   Attributes: Questionnaire, Data Analysis,Abstract  ::   1203 people found this useful

Project Department

Project Body

CHAPTER ONE

                                                                               

 

INTRODUCTION

 

 

  1. NEED FOR THE PROJECT

 

 

The general objective of the system is to provide efficiency, steadiness in the use of power appliances, by ensuring continuous availability of power supply even in the absence of mains. Uninterruptability of the system made it possible to eliminate all suspense from mains outage during the execution of an important and urgent assignment as may be required.

 

For better production of the system, the system was operated at a fully charged condition of the battery.

 

The project was rated 200W of 220V and 50Hz. It was expected that at this condition, it was favourable to carry load of the stipulated power. Loads of low power factors are not helpful since they produce spikes. Overloading is not potent to provide zero change over time and the inverter had LEDs which indicates mains failure and battery discharge and system fault.

 

  1. SCOPE OF STUDY

 

 

This solar power source makes it possible to provide a clean reliable supply of alternative electricity free of sags or surges which could be found in the line voltage frequency.

 

 

The solar power system (SPS) system achieved this by direct current from solar panel and by rectifying the standard main supply, using the direct current to charge the batteries and to provide clean alternative power by passing the energy a filter system.

 

It has zero change over time and LEDs which indicates mains fail and battery discharge level and it provides 100% protection against line noise, spikes surges and audio frequency interference.

 

  1. DEFINITION OF TERMS

 

 

    1. Inverter unit: This unit converts a DC voltage into AC voltage with the help of the inverter unit.

 

    1. Automatic Control Unit: This provides all the required control needed to meet up the objective of the whole system

 

    1. Battery Unit: This is a secondary cell unit, capable of storing enough DC voltage from either sun or AC main, of which is later converted to AC voltage.

 

 

 

Get the complete project »

Can't find what you are looking for?
Call 0906 809 7513

  • Subscribe to Free Job Alert
    Enter your email below and click subscribe

    LATEST JOB VACANCIES


    We require the services of an experienced Business Development Manager with a wide range of business clientele and a network of c... Read more

    Regulate day-to-day operations of unit in conjunction with Departmental Heads, Manager, Executive Chef, Security. Cordinate and l... Read more

    FINANCE OFFICER

    LEAD Enterprise Support Company Limited in (Lagos State)
    Job Objective: The Finance Officer will assist the Finance/Admin Manager in the implementation of the HMO’s accounting policies an... Read more

    Copyright © 2024 All Right Reserved CVClue
    A Subsidiary of EMINENT INFO TECH VENTURES